Tips for Stress free life  >  Expert Zone   > Home Improvement      

 Home Improvement Tips


Removing Your Old Sliding Glass Door


Last week I explained how to measure your existing sliding glass door so you can order the vinyl replacement door. This week I am going to go over the steps required to remove the old sliding door before installing the new door.

First, you have to remove the sliding panel and the stationary panel. The vast majority of doors out there have the sliding panel on the inside half of the track, and the stationary panel is on the outside. Whatever the case in your particular door, the outside panel has to come out first. To remove the fixed panel, you need to remove the sill cap that snaps into the bottom track and runs from the fixed panel to the side jamb where the sliding panel locks. Force a screwdriver into the crease and pry the cap up. Then, look for screws on the inside side jamb holding the fixed panel in place. These screws prevent someone from prying up the sill cap and pulling out the fixed panel in order to gain entry into the home. In addition to the side jamb, be sure to check across the top header and bottom track for screws there as well. Once all the screws have been removed, you need to pull the fixed panel away from the side jamb. You can start by simply grabbing the side rail of the fixed panel and pulling as hard as you can. If you're lucky, the panel will pop free. Then you can lift the panel up as far as it will go into the top channel and swing the bottom away from the track, and remove the panel.

Now, I said "if you're lucky", because in most cases the panel will be stuck in the side jamb, the bottom track, or both. Usually, you're going to have to use a pry bar to loosen the fixed panel before it will slide out of the side jamb. Once the fixed panel is out, removal of the sliding panel is usually easier. Just lift up and swing the bottom away from the track, then remove the panel. Sometimes the bottom rollers will prevent the bottom from swinging out of the track. If that's the case, you will need to find the roller adjustment hole in the bottom corners of the sliding panel. Put a screwdriver into this hole and turn the screw counterclockwise to bring the roller as far up into the bottom of the sliding panel as possible. This should allow the slider to come out.

Now, you want to remove all the screws from the side jambs, top header, and bottom track. Then, take a pry bar and get it under the bottom track about in the center. Pry up until the track is separated from the floor. The next step will depend on whether your old frame is nailed to the house frame, or simply screwed in. If it's screwed in, then the frame should now be loose in the opening, since you removed all of the screws. You just need to remove whatever inside trim there might be around the door frame. This type of frame should come out. If your door is nailed to the house frame, you will have to do a bit more work. Use a hacksaw to cut the track in half, approximately in the center. Start with either half and raise the cut piece up towards the side jamb until the the track piece separates from the side jamb. Do the same thing to the other half.

So, now you have to remove the side jambs. You want to do this without damaging the exterior material that surrounds the door frame. Take a heavy chisel and pound it into the crack between the frame and exterior material, whether it's stucco, siding, etc. Start at the bottom 6 inches first. What you are trying to do is pull the nail fin away from the nails holding it in place. So, once the chisel is pounded through the metal frame, pry away from the side wall. The heavier and longer the chisel, the more leverage you will have. You will hear the frame "pop" free of the nail. There will be several nails holding each jamb in place, so you want to start at the bottom and work your way to the top corner. Once you get the bottom third loose, many times you can grab the jamb with both hands and pull the rest of the nails free as you go up. When you get to the top corner, work the jamb free. Do both jambs, then do the top. Sometimes the top has no nails, or just one in the center, so it will come down pretty easily. Be sure to wear safety glasses and a dust mask when doing this job, especially when removing the top header.

At this point you are ready to install the new door. The installation procedure is slightly different, depending on whether you're installing a retrofit style frame or a replacement frame. We will discuss both procedures next week.

John Rocco has been installing replacement windows since 1978. To learn more, visit How To Install Windows


MORE RESOURCES:

Go Debt Relief, Now a Member Lexington Chamber of Commerce
PR.com (press release), NY - 3 hours ago
Go Debt Relief is assisting people struggling with their high interest rate credit cards, medical bills, collection accounts and many other types of ...


IMF, Paris Club applaud debt relief grant
WOW, Gambia - 19 hours ago
In December of 2007, the International Monetary fund (IMF) granted The Gambia a milestone debt relief package worth $140 million. In a statement at time, ...


Senate funds veterinary student debt relief program
American Veterinary Medical Association, IL - 20 hours ago
Congress passed NVMSA in 2003 to offer school debt relief to veterinarians who opt to work in underserviced areas, such as rural communities experiencing a ...


Mozambique: Mozambican government negotiates foreign debt relief ...
Macauhub, Macau - Aug 19, 2008
Maputo, Mozambique, 19 Aug – The Mozambican government is negotiating with Libya and Bulgaria the relief of its debt to those non Paris Club countries ...


Law students being offered debt relief for picking public service ...
Norman Transcript, OK - Aug 18, 2008
By Julianna Parker Law students who want to pay off debt quickly now will have an incentive to enter public service. A measure recently signed into law will ...


ABC News

FACTBOX-Zambia's late President Levy Mwanawasa
Reuters South Africa, South Africa - 22 hours ago
Mwanawasa was a favourite of the International Monetary Fund and other Western donors who extended billions of dollars in debt relief in the wake of his ...
Zambian president Mwanawasa dies in France, aged 59 guardian.co.uk
Zambian President Levy Mwanawasa dies at 59 The Associated Press
Zambian President Mwanawasa dies in France Reuters
AfricaNews - Reuters South Africa
all 576 news articles


Banks to get Rs 250 bn for farm debt relief by Sept end
Myiris.com, India - Aug 14, 2008
As per the senior finance ministry official, the government will provide first tranche of Rs 250 billion to banks by the Sep. 30, 2008 for Rs 710 billion ...


IRS Debt Relief Specialists Resolve Real Life Tax Cases at ...
PR.com (press release), NY - Aug 14, 2008
Tax Resolution Specialists take IRS negotiation skills to the next level at special seminar on tax relief strategies like offer in compromise, ...


Zee News

Banks to get Rs 25000 cr for farm debt relief by Sept 30
Zee News, India - Aug 13, 2008
New Delhi, Aug 13: The government will provide first tranche of Rs 25000 crore to banks by the September end for Rs 71000 crore debt waiver and relief ...


Some income not useable in bankruptcy
InvestmentNews, NY - 14 hours ago
In addition, Congress and President Bush passed the Mortgage Forgiveness Debt Relief Act of 2007, which provides that if the amount of debt forgiven is ...

Debt-Relief - Google News

You are here Home > Tips for Stress free Life > Expert Zone > Home Improvement


| Home Improvement  | Home Improvement - Complete list 

| Main Home | | Meditation Corner

                |Health Tips  | Workplace Tips  | Soul Tips  |Expert Zone  |

Recommend us  |

 Books, DVDs and accessories on meditation & yoga  |

[About us] [Contact] [Privacy Policy]

Copyright 2006, Meditation is Easy.com, All rights reserved